Weekly Use:
1. Turn OFF all equipment.
2. Turn ON air blower or spa jets.
3. Add Bright & Clear directly to spa. Use 2 oz. for spas up to 800 gallons. Use 4 oz. for spas over 800 gallons.
4. Allow blower or jets to run a few minutes.
5. Turn ON filter system until water is bright and clear.
 

Directions For Use:
1. Clean or backwash the filter before use.
2. Water should be balanced and the chlorine and the bromine level should be 0.5 to 3.0 ppm.
3. Regular dosage is four (4) ounces per 500 gallons of water to be treated. This dosage may be increased to eight (8) ounces per 500 gallons if the water is particularly dirty.
4. Apply dosage over the surface of the water to be treated with your system running.
5. Allow system to filter for 1-2 continuous hours. Clean filter only if back pressure increase reaches level that the filter manufacturer directions specify.
6. Treat with regular dosage once every week to maintain exceptional clear water.

 

Standard Dosage:
Use 1 fl. oz. per 500 gallons of spa or hot tub water, no premixing required.

Cloudy Water Dosage:
For especially dirty or cloudy water, double or triple the standard dosage.

Weekly Maintenance:
To keep spa or hot tub water clear and clean, use once a week at the standard dosage. For heavy use or commercial spas or hot tubs, product can be used twice weekly at double or triple the dosage.
1. Make sure filter is clean and all equipment is working properly.
2. Squirt the calculated amount into the water with filter running and jets on high. Run filter system continuously for at at least one hour after application.
 

Standard Dosage:
1 tablet treats 500 gallons, use 1 tablet per week. Place tablet into the skimmer or filter area. Be sure to replace tablet once a week.
 

Notes:
Spa Clear & Perfect may be oxidized by high levels of sanitizer.
Do not use Spa Clear & Perfect within 24 hours of using Spa Metalfree or any other metal remover or stain remover.
Do not use this product through the skimmer.
Spa is safe to use 15 minutes after application of Spa Clear & Perfect.

Initial and Troubleshooting Dosage Rate:
With circulation pump running, sprinkle over surface of spa water 1 capful ( 4 oz ) per 400 gallons. ( 1 oz. per 100 gallons )

Weekly Maintenance Dosage Rate:
With circulation pump running, sprinkle over surface of spa water 1/2 capful per 400 gallons. ( 1 oz. per 200 gallons )
Note: Take care not to overdose.

Tip:
Use Natural Chemistry's Spa Perfect weekly following treatment with Spa Clear & Perfect to breakdown organic material and debris on filter.